How to Take Care of Your Bike

How to Take Care of Your Bike

You are relying on your bike to get you where you want to go, and get there safely. A small amount of maintenance will pay dividends in terms of your riding enjoyment, plus a well maintained bike is a safer and more comfortable bike.

How often you need your bike serviced always depends on use and how well you look after it. As a general rule of thumb though Reid recommend you get your new bike serviced after 6 weeks of riding for adjustments as parts bed in. Following this it makes sense to at least get a professional service pre-Summer and pre-Winter.

In between services though you should perform the following few checks each week to keep things rolling smoothly.


What are the most important elements for safety?

Feeling a bit flat?

Check your tyres often as they may deflate over time. Tyres that are not at the right pressure make it much harder to ride. Floor pumps make this much quicker and easier than hand pumps and start at around $30. As a rough pressure guide, road bikes need to be around 100 psi, hybrids around 70 psi and mountain bikes around 50 psi.

Failing to stop

Unless you are a competitive track cyclist - brakes are important. They last quite a long time, but are super quick to check. Look to see that the brake pads are not too worn – there are lines cut into the pad (see brake pad image below). If you can’t see these, then it’s time for new ones. Also check that they line up with the braking surface on the rim (the silver part, usually) and aren't rubbing on your tyres. For more detail on adjusting your brakes read our 15 minute service guide.

Riding dirty

A dirty and over lubricated chain is not only the scourge of trouser legs worldwide, but also the most common problem seen by bicycle mechanics. A greasy chain attracts dirt and causes more wear to all the parts it touches in the drivetrain. To keep your chain in good order you will need some lube and a rag.

Pop the bike upside down and liberally apply lube to the chain at the rear cassette (the gears at the back). Turn the pedals backwards for around five seconds and then use a rag to wipe off the excess lube. Really wipe the chain, it can’t be too clean! The lube will be inside the links but the cleaner the outside is, the longer the chain and cassette will last. Be careful while wiping the chain - don’t let the rag get snagged or your fingers caught.

Checking your nuts

Wheel nuts or skewers (some bikes have nuts, some have quick release skewers) and the main bolts on your head stem, saddle, seat post, cranks and rear rack should stay tight, but it is worth just checking them every now and again. Popping an allen key into each nut/bolt or putting a spanner on and giving it a quick tighten is a good way to test. You don’t want anything coming loose in the middle of your ride. Check out our tools if you're in need of a few essentials.

Sparkling Clean

Like your car, bikes love a good clean every now and again. The easiest way is to clean your bike with a soft foam pad like you would use on the car with a bucket and a hose. Just be careful not to spray the hose at full power into sensitive areas. If you can, use a very soft head on the hose. You can also use a dedicated product such as Zefal Bike Wash.

Gears a bit cranky?

If you have gears that sound a bit rough or are not shifting properly, it might be time to book in that annual service. If your Reid bike is less than 12 months old, we’ll service it free. Otherwise services start at just $35 and give you piece of mind. Read on for more about servicing.

As always, the Reid Cycles stores are happy to provide advice over the phone or in person about what servicing and maintenance you might need on your bike. Click here for more info. If you give your bike a little love, it will love you back with years of happy and reliable riding!

Back to blog
1 of 3